Trois situations de la valeur effective du multimètre
Le sens de la valeur effective, vrai effective valeur et racine moyenne carré valeur dans le multimètre, et trois situations de la valeur effective de le multimètre: la norme moyenne méthode, le pic détection méthode, et la vrai valeur effective méthode.
For alternating current, its voltage is a changing waveform, and its voltage value is usually ddescribed as its effective value. For example, the 220V power supply has a peak voltage of more than 310 volts and a peak-to-peak value of more than 600 volts.
1. Effective valeur: It is defined by heat generation (power). A certain alternating current generates heat through a resistor and another direct current passes through the resistor. If the heat generated in the same time is equal, then the direct current voltage value is this alternating current. The effective value of the voltage.
2. True RMS: The definition of RMS is defined by heating, but it is difficult to measure the RMS voltage in this way in measuring instruments, so in most voltage measuring instruments, such as multimeters measure voltage, Its measurement method is not measured according to the "heat" defined by the effective value. Un du multimètres utilise le sinus onde as a référence, et la valeur effective est obtenue par la relation entre la valeur crête de la sinuse onde et la valeur effective deux fois la racine signe (ou Dérivée par la moyenne valeur), la valeur effective obtenue par ce méthode est only correct for the AC voltage of the sinusoidal waveform, and there will be deviations for other shapes of the waveform.
Another type of multimeter voltage value is obtain by the square of the effective value of the DC component, the fundamental wave, and each higher harmonic. This value is similar to the definition of the effective value, and there is no requirement for the shape of the waveform. The sine wave is different from the effective value instrument, which is called "true effective value" in the measuring instrument.
3. Racine moyenne carré valeur: Autre nom pour valeur effective (devrait être vrai effectif valeur on le mesure instrument).
1. Calibration moyenne valeur méthode, le étalonnage moyenne valeur est aussi appelé le corrigé moyenne valeur, ou le rectifié moyenne valeur calibré à la valeur effective. Le principe est à convertir le AC signal en a DC signal traversant la rectification et intégration circuit, et alors accordant à les caractéristiques de la sinusoïde, Multiplié par a coefficient, pour a sinus onde, après multiplication par ce coefficient, le résultat est égal à la valeur effective de la sinusoïde onde. Therefore, this method is limited to sine wave testing.
2. Le pic détection méthode obtient le crête valeur de le AC signal par le crête détection circuit, et alors multiplie it par a coefficient accordant à les caractéristiques de le sinus onde onde. pour le sinus onde, après multiplication le coefficient, le résultat est égal à la valeur effective de la sinusoïde onde. Par conséquent, ce méthode est limitée à sinus onde test.
3. True RMS method, using a true RMS circuit to convert the AC signal into a DC signal and then measure. This method is suitable for the true RMS test of arbitrary waveforms. Most multimeters use the first two methods. And there is a big limit to the frequency of the signal.
